Generally the water line repair cleanup required for clean water damage is far less. All you have to do is completely dry out your home. After everything has dried, check for mold. By leaving all windows and doors open, your home will dry much more quickly.
Turn off the water to the water line repair heater or if the valve is not working turn off the water to the house. If the valve is not working it will need to be replaced. In a future article we will discuss how to replace your valve.
One other common design that is considered "washerless" was made famous by Delta and copied by several other makers. It uses little "cup" seals that fit over springs recessed in the back of the valve body. The springs press these "seals" against the cartridge and regulate the flow through little tapered openings in the cartridge. If you have one of these and it's dripping, changing these springs and seals will usually correct it. Here's a tip. Once you have the cartridge out of the way, insert a phillips screwdriver into the seal and pop both the seal and spring out. Stick the new ones on the end of the screwdriver to help guide them into place. This is especially helpful if you don't have long slender fingers.
Once you have disconnected the tank remove it from your work space. Do a thorough measurement of the remaining pipe for reference when you go to the hardware store. I will be honest with you, you might need to make a few trips back to the store. Once you get the new tank, slide it into place to line up the plumbing.
As with anything, when you are not sure how to fix a plumbing issue and when you don't have the proper equipment, you should contact a professional. They can usually find out what the problem is and resolve it for you in a short period of time. They will also be able to tell you if you have any other problems and water line repair they can suggest resolutions.
When doing the install on a water heater, keep an eye out for unconnected pipes. A commonly missed pipe is the one that leads out from the area for drainage. It is probably a recirculation pipe; that helps your water remain heated without wasting too much water.
Windshield repair techs come and go on a daily basis. The majority struggle to survive. Most fail. It's not that they're not good at what they do, it's not that they don't have the skills, it's not that they're not willing to work hard, it's their lack of MARKETING Training. That's the bottom line: It all comes down to proper marketing strategies.